Friday, April 8, 2011

Tips on Using Rapid Armor

by Ethan Schneider

Although we have discussed specific instructions in reference to Rapid Armor application, it is essential that the product in the cans be within the proper temperature range prior to mixing and application. The temperature range should be within 70 to 80 degrees farhenheit, ideally 75 degrrees. If the product is to cool say 60 to 65 degrees, it will be much thicker and require much more effeort and pressure on the foam roller to spread out. This will cause micro bubbles to be forced into the product.

On the other hand, if the cans are left in a hot trailer say 90 to 105 degrees or hotter, then the pot life when mixed will decrease dramatically resulting in very little application time before the product starts to set up.

Ideally at approximately 75 degrees, the Rapid Armor should flow very smoothly with little effort. You know it's right if it literally tends to slide over itself when very lightly pushed with a foam roller.

Be sure to remove dust anf debris from the surface before application. Try to control the environment as much as possible to reduce airborne debris, this includes closing or blocking air vents from heat or air conditioning. Check foam rollers for dust and debris before use. Do not sand any surfaces and then apply Rapid Armor in the same location. Try to prevent doors from opening and closing in close proximity to the tacky Rapid Armor, check your cloths, and hair etc. for additional dust and debris. always double mix Rapid armor in a clean pale.

It is not recommended to ratio mix this product. If a small amount is required then use a 1 quart kit instead of the 1 gallon kit. If you have additional questions or concerns, don't hesitate to consult with the tech department at CTI prior to application.