Coverage for CTI Products

Hallmark System Estimated Coverage
Series 105 Polymerized dry component 100 – 125 s/f per 50 lb. Bag (skim & spray)
Series 110/111/112 Polymerized Wet component 400 – 500 s/f per 5 gal. Bucket
Series 150 Cure and Seal 400 – 500 s/f per 5 gal. Bucket (2 coats)
Series 190 color integration component 400 – 500 s/f per quart bottle

Sealers
Pro Seal 200 (clear and colors) 80 –100 s/f per gallon at 2 coats
Aquathane 6000 80 – 100 s/f per gallon at 2 coats
Super Seal 210 Epoxy 100 s/f per gallon at 1 coat
Series 155 400-500 s/f per 5 gal at 2 coats
Rapid Armor 100-125 s/f per gal at 1 coat.

Preparation materials
Fast Crack 1431 40-60 linear feet per unit
Enviro Prime ¾ gal. Kit 100-250 s/f
High Density Mortar 12 s/f at ½” or .40 cubic feet
Series 280 Waterproof Membrane 100 s/f per kit

Durafleck System
Series 5000 Binder 100 – 125 s/f per gallon
25 lb. Box of PVA Chips 500 s/f

Tapes
¼” filament tape 180 feet
½” filament tape 180 feet
½” filament brick tape 180 feet
¾” filament tape 180 feet
1” Masking tape 180 feet

NOTE: CTI makes no specific claims as to the actual coverage of its products. Certain variables may effect the coverage of certain products and your results may vary.

Spraymark System

The CTI Spraymark system is very similar in appearance to the Hallmark system. There are however, a few differences that make the Spraymark system considerably more economical and less labor intensive.

The two main differences between the Hallmark and Spraymark systems is the Spraymark is applied without the application of a skim coat. In other words, the entire job is simply sprayed 100% over the bare prepped concrete, and then highlighted and sealed.

In order to eliminate the skim coat a new more advanced modifier was formulated for the Spraymark system . The 112 modifier utilizes nano technology in order to provide better adhesion without the skim coat. The mix ratio’s for the 112 modifer are the same as the regular 110 and 111 modifiers, and they are interchangeable. 112 Modifier can be used for all other CTI applications.

Applications best suited for the Spraymark system are those that require little if any concrete repairs and few serious cracks. Cracks are addressed by simply sponging grout directly into the crack before spraying.

Generally, the Spraymark system does not incorporate any patterns due to the lack of a skim coat. However, patterns can be taped out on the bare concrete prior to spraying. The Spraymark system requires about 1/3 less material and about ½ the labor of the hallmark application and can therefore be sold at a lower price. The Spraymark system offers a 1 year warranty similar to the Designers series. It is a highly cost effective alternative.